COB vs SMD Work Lights: Which LED Type to Choose
COB (chip-on-board) work lights pack many small LED chips onto one flat panel, so they give a wide, even light with soft shadows — the usual choice for engine bays, benches and area lighting. SMD work lights use separate LED packages, usually behind a lens or reflector, so they throw a more focused beam further — better for spot and torch use. 37 of our 44 models use COB, and 3 combine COB and SMD LEDs in one light.
| COB | SMD | |
|---|---|---|
| How the light looks | One continuous glowing panel | Separate bright points, often behind a lens |
| Light pattern | Wide flood, even across the work area | Narrower beam, brighter centre |
| Glare and shadows | Lower glare per point; one soft shadow | More glare if you look at it; can cast multiple shadows |
| Throw distance | Short to medium | Medium to long |
| Typical work-light use | Underhood bars, magnetic stick lights, floodlights, lanterns | Flashlight heads, spotlights, the "torch" end of 2-in-1 lights |
General comparison of the two LED types; output, battery and runtime of each model are on its product page.
Which is better for car repair — COB or SMD?
For most car repair work COB is the better fit: an underhood bar or a magnetic COB stick light spreads light over the whole engine bay or wheel arch without hot spots. Keep an SMD spot or pen light for looking deep into a narrow gap. Browse automotive work lights or underhood bars.
How many lumens does a work light need?
For close inspection 200–600 lm is usually enough and avoids glare; for bench work 500–1,000 lm; for a whole garage bay or jobsite choose 2,000 lm and above, or two lights crossing each other. Compare output side by side in the spec finder.
How long does a rechargeable work light run?
It depends on the mode and the battery. Across the 11 of our models with a stated runtime, the longest mode runs from 3.5 to 15 hours; high mode is usually much shorter. Each product page lists the runtime per mode from the specification — see rechargeable work lights.
FAQ
More about LED types
Is COB brighter than SMD?
Not by itself — brightness depends on the lumen rating and the driver, not on COB or SMD. Compare the lumen figure on each product page.
Can you make a model with both COB and SMD?
Some of our models already combine COB and SMD LEDs in one light. For private-label orders, tell us the model and we confirm what can be changed.
Request samples or a quote
Tell us what you need
Product type and quantity are enough for a first price; add model numbers if you have them. Add your logo and target market if you need private label.
- MOQ 500 pcs per model
- Bulk lead time 7–35 days
- Sample cost quoted per model before anything is sent
Or email sales6@nhruichi.com

